LIST OF ALL SUITABLE VEHICLES
For version with liftig roof
The following vehicles are compatible with the PlugVan with lifting roof:
- VW Crafter und MAN TGE
- Mercedes Sprinter
- Fiat Ducato / Peugeot Boxer / Citroën Jumper
- Opel Movano / Renault Master / Nissan NV 400
- Ford Transit (not Transit Custom)
- Iveco Daily
- Hyundai H350
Outer dimensions
- Lenght: 2.05m
- Width: 1.28m (retracted) to 1,88m (extended)
- Height: 1.72m (retracted) to 2.02m (extended)
Please note: Dimensions given without supports

For Version without lifting roof
The following vehicles are compatible with the PlugVan without lifting roof:
- VW Crafter und MAN TGE
- Mercedes Sprinter
- Opel Movano / Renault Master / Nissan NV 400
- Iveco Daily
Outer dimensions
- Lenght: 2.05m
- Width: 1.28m (retracted) to 1.88m (extended)
- Height: 1.80m
Please note: Dimensions given without supports

Please note
Generations of vehicles
The data for compatible vehicles refers to the latest models of January 2019. There are usually only very minor dimensional changes in the cargo area when the panel van models are changed to a new generation. In the case of the Mercedes Sprinter and VW Crafter, for example, the previous models are also compatible in any case. In case of doubt, please contact us.
Roof versions
Please note that the rear door height must be 173 cm over a width of 128 cm. This is always given for vehicles with "standard high roof" (usually referred to as "height 2", short: H2) or higher roofs. This is sometimes not given for vehicles with "height 1". In case of doubt please contact us.
Length versions
All length variants are basically supported. However, it should be noted that up to now we have only systematically recorded the lashing point positions in the load compartment floor for all vehicles with "medium wheelbase" (typically just under 6 meters external length). Other vehicles may have unfavorable positions, which may make an adequate load securing difficult or even impossible. Please contact us in case of doubt.
Other restrictions
- Vehicles with twin tires are currently not supported (insufficient distance between the wheel arches)
- The distance from the end of the vehicle (including the outside step) to the end of the load compartment floor must not exceed 70 cm. This distance should be measured as a precaution in the case of extremely projecting steps. We are currently not aware of any variants where this distance is exceeded.
- If wheel housings are installed (typically wood sheathing), the distance between the wheel housings must be at least 130 cm
- The loading edge height must be between 50 and 73 cm. We are currently not aware of any variants where this range is not complied with. For lower or higher vehicles this height should be measured as a precaution.